MPV LX V6-2.5L DOHC (2000)
Axle Shaft: Service and Repair
Constant Velocity Type
Removal and Installation
DRIVE SHAFT REMOVAL/INSTALLATION
Caution:
-
Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is
pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place
where the sensor will not be pulled by mistake while servicing the vehicle.
Removing the right side drive shaft with the shaft bracket installed may cause the deformation of the joint shaft bracket. Therefore, remove/install
the right side drive shaft and joint shaft as a component.
1. Drain the transaxle oil.
2. Remove the steering knuckle, wheel hub and dust cover component (Right side).