MPV LX V6-2.5L DOHC (2000)
10. Install the spacer and fasteners onto the glass as shown.
CAUTION: Keep the area free of dirt and grease, and do not touch the surface or the primer may not properly bond to the surface of the glass
and body, which may cause leaks to occur.
11. Use a brush to apply primer to the bonding area of the glass, the body and the molding within the region shown. Use only glass primer on the
glass, and body primer on the body and the molding. Allow it to dry for approximately 30 minutes.
12. Once the primer is dry, apply sealant around the entire circumference to the edge of glass with a 11.0 mm {0.43 in} high and 5.0 mm {0.20 in}
wide bead of sealant.
13. Align the pins and install the glass on the body.
14. Verify that the gap along the each edge is as shown.
