MPV LX V6-2.5L DOHC (2000)
7. Install the front windshield molding in the direction shown by the arrow. (2)
8. Temporarily install the glass onto the body and adjust the glass-to-body clearance.
9. Make a mark on the glass directly above the V-notch of spacers.
10. Remove the windshield.
11. Paste the fasteners on the body as shown.
CAUTION: Keep the area free of dirt and grease, and do not touch the surface or the primer may not properly bond to the surface of the glass
and body, which may cause leaks to occur.
12. Use a brush to apply primer to the bonding area of the glass, the body, and the molding within the region shown.
NOTE: Use only glass primer on the glass, and body primer on the body and the molding. Allow it to dry for approximately 30 minutes.
