MPV LX 4WD V6-3.0L SOHC (1997)
11. Remove the cylinder head.
^
Loosen the cylinder head bolts in two or three steps in the order shown.
^
Remove the cylinder head.
12. Remove the cylinder head gasket.
INSTALLATION
1. Install the cylinder head.
a. Measure the amount of oil control plug projection from the deck of the cylinder block.
Projection: 5.3-5.7 mm (0.209-0.224 in)
b. Apply clean engine oil to new O-rings and install them to the oil control plugs.
c. Thoroughly remove all dirt, oil, and other material from the top of the cylinder block.
d. Turn the crankshaft clockwise and apply engine oil to the cylinder walls.
e. Place a new cylinder head gasket on the left bank with the L mark facing upward.
f.
Place a new cylinder head gasket on the right bank with the R mark facing upward.
g. Install the cylinder head to the cylinder block.
h. Tighten the cylinder head bolts.
Head Bolt Length
(1) Before installation, measure each bolt length. Replace if necessary.
Length
IN: 107.7-108.3 mm (4.25-4.26 in)
EX: 137.7-138.3 mm (5.43-5.44 in)
Maximum
IN: 109 mm (4.29 in)
EX: 139 mm (5.47 in)
