MPV LX 4WD V6-3.0L SOHC (1997)
Throttle Full Close Switch: Service and Repair
1. Disconnect the throttle position sensor connector.
2. Remove the attaching screws.
3. Remove the throttle position sensor.
4. Verify that the throttle valve is at the closed throttle position.
5. Open the throttle valve slightly and catch the tang of the throttle body on the throttle position sensor plastic tabs. Align tang A on throttle body
with tab A on throttle position sensor. Note tangs on the throttle body mate with the tab on the throttle position sensor on the side of the tab
without a slot.
6. Position the throttle position sensor on the throttle body so that the mounting holes align.
7. Install and hand tighten the attaching screws.
8. Release the throttle.
9. Adjust the throttle position sensor output voltage and closed throttle position switch. (Refer to Throttle Position Sensor/Adjustments).
See: Throttle Position Sensor/Adjustments
