MPV LX 4WD V6-3.0L SOHC (1997)
Engine Control Module: Component Tests and General Diagnostics
With SST-Engine Signal Monitor
CAUTION: The PCM terminal voltages vary with change in measuring conditions and vehicle conditions. Always carry out a total inspection of the
input systems, output systems, and PCM to determine the cause of trouble. If this is not done, a wrong diagnosis will be made.
Using SSTs (Engine Signal Monitor)
1. Disconnect the negative battery cable.
2. Remove the PCM.
3. Connect the SST (Adapter harness) to the PCM.
4. Connect the SSTs (Monitor, Engine Signal and Harness adapter, power) to the SST (Adapter harness). Use connector A of the adapter harness for
PCM terminals 1 A through lv and 3A through 3P. Use connector B for PCM terminals 2A through 2L and 4A through 4Z.
5. Place the SST (Sheet) on the SST (Monitor, Engine Signal).
6. Measure the voltage at each PCM terminal by switching the selector switch and the monitor switch.
