MPV LX 4WD V6-3.0L SOHC (1997)
Stabilizer Bar: Service and Repair
Rear
REMOVAL / INSTALLATION
1. Jack up the rear of the vehicle and support it on safety stands.
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the
harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an
appropriate place where the sensor will not be pulled by mistake while servicing the vehicle.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal indicated in the table.
Stabilizer Bushing And Bracket (5)
1. Install the bushing.
2. Align the bushing with the stabilizer installation mark.
3. Install with the stabilizer brackets and hand-tighten the bolts.
4. Lower the vehicle, then tighten the bolts to the specified torque with the vehicle unloaded.
Tightening torque: 35 - 50 Nm (26 - 37 ft. lbs.).
