MPV LX 4WD V6-3.0L SOHC (1997)
29. Install the transmission fluid temperature sensor and tighten to 6.9 - 8.8 Nm (61 - 78 inch lbs.).
30. Connect the torque converter clutch solenoid connector.
31. Install the clip.
32. Remove any old locking compound from the bolt holes.
33. Set the magnet into the oil pan.
34. Install the oil pan along with a new gasket.
CAUTION: When installing sealant-covered bolts, tighten them immediately. Leaving these bolts in a half-installed condition could cause them
to be stuck that way, due to the natural hardening of the sealant.
35. Tighten the new bolts evenly and quickly to 6.9 - 8.8 Nm (61 - 78 inch lbs.).
36. Add approximately 4.0 liters (4.2 quarts) of ATF, and check the ATF level.
37. Carry out the line pressure test and time lag test.
38. Carry out the road test.
