MPV LX 2WD V6-3.0L SOHC (1998)
-
Pull the tab to disconnect the connector as shown in the image.
ABS Hydraulic Unit And Control Module Removal / Installation Note (3)
-
When removing/installing the ABS hydraulic unit and control module from/to the vehicle, attach protective tape on the Hydraulic Unit (HU)
connector to prevent brake fluid from entering.
ABS Control Module Removal Note (4)
1. Install the screw plugs (supplied in the service part kit) onto the brake pipe holes of the HU.
2. Disconnect the motor connector as follows.
CAUTION: Do not apply force on the locking tab when disconnecting the connector.
1) Lift up the tab to unlock the connector by hand.
2) Pull the connector from the ABS CM by grasping the side of the motor connector.
3. Carefully pull the wiring of the pump motor out of the cable guides.
4. Secure the HU as shown.
5. Remove the bolts.
6. Protect the HU from damage to the valve body and keep the sealing surface free from foreign materials.
ABS Control Module Installation Note (4)
1. Verify that the sealing surface of the HU is clean. If there are scratches, grooves or dirt, do not mechanically rework. Carefully remove any dirt or
seal residue with plastic tools only. The use of chemical solvents is not permitted.
