MPV LX 2WD V6-3.0L SOHC (1998)
NOTE: If the diameter is less than the specification, grind the journals to match an undersize bearing.
UNDERSIZE BEARING .................................................................................................................................................................. 0.25 mm {0.01 inch}
Crankshaft
End play ..............................................................................................................................................................
0.080 - 0.282 mm {0.0032 - 0.0111 inch}
Maximum ........................................................................................................................................................................................
0.30 mm {0.0188 inch}
NOTE: If the end play exceeds the maximum, grind the crankshaft and install an oversize thrust bearing or replace the crankshaft and thrust bearing.
Thrust bearing width:
Standard:
............................................................................................................................................................................
2.000 - 2.050 mm {0.0799 - 0.0807 inch}
.............................................................................................................................................................................................
0.25 mm {0.01 inch} oversize:
.........................................................................................................................................................................................................
0.50 mm {0.0188 inch}