MPV LX 2WD V6-3.0L SOHC (1998)
Refrigerant Control Solenoid Valve: Service and Repair
1. Disconnect the negative battery cable.
2. Discharge the refrigerant from the system.
3. Remove the driver's rear side trim.
CAUTION:
-
If moisture or foreign material enters the refrigeration cycle, cooling ability will be lowered and abnormal noise will occur. Always
immediately plug all open fittings after removing any refrigeration cycle parts to keep moisture or foreign material out of the cycle.
-
To prevent the pipe from breaking, loosen the joint by using two open-end wrenches.
4. Remove in the order indicated in the table.
CAUTION:
-
To prevent the pipe from breaking, tighten the joint by using an open-end wrench and a torque wrench.
-
To prevent the O-ring from breaking, tighten the nut of the joint by hand.
5. Install in the reverse order of removal indicated in the table.
6. Install the driver's rear side trim.
7. Charge the system and test its performance.
A/C Solenoid Valve installation Note
1. Apply compressor oil to the O-rings and connect the joint.
2. When installing a new A/C solenoid valve, add ND-OIL8 compressor oil into the refrigeration cycle.
Supplemental amount 10 ml (10 cc, 0.3 fl.oz)
