MPV LX 2WD V6-3.0L SOHC (1998)
Air Flow Meter/Sensor: Testing and Inspection
Air Flow Meter Sensor Inspection
1. Check the mass air flow sensor for damage and cracks.
2. Warm up the engine to normal operating temperature.
3. Shift the selector lever to P
4. Turn off all electrical loads.
(1) Headlight
(2) Blower motor
(3) Rear window defroster
(4) Power steering
5. Wait until the cooling fan stops.
6. Connect the SSTs (NGS tester) to the data link connector-2 located under the driver side dashboard.
7. Select the "PID/DATA MONITOR AND RECORD" function on the NGS tester display.
8. Select "MAF V" on the NGS tester display. NGS tester measures and shows the voltage.
Specification Chart
9. If not as specified, inspect the following.
(1) Harness continuity
(1) Between PCM terminal 3B and mass air flow sensor terminal B
(2) Between PCM terminal 4A and mass air flow sensor terminal E
(3) Between main relay terminal D and mass air flow sensor terminal A
(2) Mass air flow sensor terminal A voltage:
Battery positive voltage (Ignition switch ON)
10. If there is incorrect terminal voltage or harness continuity, replace the mass air flow sensor.
