MPV LX 2WD V6-3.0L SOHC (1998)
Air/Fuel Mixture: Adjustments
ENGINE TUNE-UP
Preparation
1. Warm up the engine to normal operating temperature.
2. Shift the transmission into P position.
3. Turn off all loads.
1. Headlight
2. Blower motor
3. Rear window defroster
4. Power steering
4. Connect the SSTs (NGS) to the data link connector 2 located under the driver side dashboard and select the "PID/DATA MONITOR AND
RECORD", function.
5. Select "RPM" on the NGS display.
6. Press SET UP and turn the test mode on. (press ON)
7. Press CANCEL.
8. Press START.
Ignition Timing
1. Perform "Preparation".
2. Verify that the idle speed is within the specification; if not, adjust it.
Specification:
500 - 900 rpm
3. Verify that the timing mark (yellow) is within the specification.
Specification:
BTDC 10 - 12° (11 ± 1°)
4. If not as specified, loosen the distributor lock bolts and turn the distributor to make the adjustment.
5. Tighten the distributor lock bolts to the specified torque.
Tightening torque:
19 - 25 Nm {1.9 - 2.6 kgf/m, 14 - 18 ft. lbs.}
6. Verify that the idle speed is within the specification.
7. After adjusting the ignition timing, press SET UP and turn the test mode off. (press OFF)
8. Press CANCEL.