Testing and Inspection of Transmission Position Switch/Sensor for MPV LX 2WD V6-30L SOHC
Transmission Position Switch/Sensor: Testing and Inspection
TRANSMISSION RANGE SWITCH INSPECTION
1. Remove the selector cable.
2. Remove the manual shaft nut and lever.
3. Disconnect the transmission range switch connector.
4. Check for continuity between the terminals.
5. If not correct, adjust the transmission range switch.
6. Connect the transmission range switch connector.
7. Install the manual shaft nut and lever.
Tightening torque
30-39 Nm (3.0-4.0 kgf-m, 22-28 ft. lbs.)
8. Install the selector cable.