MPV LX 2WD V6-3.0L SOHC (1998)
Components (Without Towing Package)
Radiator (In Tank Oil Cooler) Installation Note
1. The automatic transmission oil cooler flushing must be performed whenever a transmission is removed for service to remove existing fluid which
may be contaminated to prevent contamination of new fluid. The flushing must be performed after installation of the overhauled of replacement
transmission.
2. Follow the instruction in the manufacturers publication for flushing operation.
Oil Hose Installation Note
CAUTION:
-
In order to prevent ATF leakage, replace the hose when any damages are found inside or outside of the hose, especially on areas contacting with
pipes.
1. Apply compressed air to cooler-side opening, and below any remaining dust and foreign material from the cooler pipes. Compressed air should be
applied for no less than one minuets.
2. Align the marks, and slide the oil cooler hose onto the oil cooler pipe until it is fully seated against the ridge.