MPV LX 2WD V6-3.0L SOHC (1998)
20. Set the accumulator springs into the control valve body as shown.
21. Verify that the manual valve and manual shaft are assembled correctly.
22. Set the control valve body into the transmission case and secure it.
23. Install bolts A and B and the brackets as shown.
Bolt length (Measured from below the head)
A: 33 mm (1.299 inch)
B: 45 mm (1.772 inch)
24. Tighten the bolts in sequence.
Tightening torque
6.9-8.8 Nm (70-90 kgf-cm , 61-78 inch lbs.)
25. Apply ATF to the new O-ring and install it onto the oil strainer.
