MX-3 L4-1597cc 1.6L (1992)
ABS Main Relay: Testing and Inspection
Fig. 69 ABS Fail Safe Relay Terminal Identification
When testing fail safe relay refer to Fig. 69 for terminal identification of ABS connector.
1.
Measure resistance between terminals C and D of ABS relay connector, resistance should be between 60-100 ohms.
2.
Check between terminals A and E, continuity should exist, then check between terminals B and E, continuity should not exist.
3.
Apply 12 volts to terminals D and C, check between terminals B and E, continuity should exist. Check between terminals A and E, continuity
should not exist.
4.
If relay is not as specified, replace.