MX-3 L4-1597cc 1.6L (1992)
3.
Bend the guide plate claws so that the distance between the claws is 10.8 mm.
4
Replace the main sleeve.
NOTE:
Apply grease to the outside of the main sleeve and inside of rubber boots.
5.
Clean the knuckle installation surface and install guide plates and caliper.
6.
Tighten the sleeve bolt.
Tightening Torque: 49.0 - 58.8 Nm (5.0 - 6.0 kgfm, 36.3 - 43.5 ft.- lbs)
7.
Repeat procedure on other side of vehicle.
8.
Verify repair.
PARTS INFORMATION
WARRANTY INFORMATION
(Applies To Verified Customer Complaints On Vehicles Covered Under Normal Warranty. Refer To The SRT Microfiche For Warranty Term
Information.)
Warranty Type:
A
Symptom Code:
82
Damage Code:
9C