MX-3 L4-1597cc 1.6L (1992)
3.
Locate the A/C relay (near the passenger side shock tower, figure 2) and disconnect it from the existing A/C harness.
4.
Plug the 6-terminal male connector of the new sub-harness into the A/C relay.
5.
Plug the 5-terminal female connector of the new sub-harness into the existing A/C harness.
6.
Remove the coolant reservoir and the fresh air duct.
7.
Route the new sub-harness along the existing A/C harness.
8.
Tie-wrap the new sub-harness along the A/C harness at each of the 9 existing tie-wrap locations.
9.
Disconnect the A/C harness from the main fuse box. The connector is located in the front part of the fuse box and is the connector closest to the
fender.
10.
Plug the 4-terminal male connector of the new sub-harness into the main fuse box (figure 2).
11.
Plug the 4-terminal female connector of the new sub-harness into the existing A/C harness.
12.
Connect the battery negative cable. Start the engine. Turn on the A/C and verify that both cooling fans are operating.
13.
Reinstall coolant reservoir and fresh air duct.
PARTS INFORMATION
PART NUMBER
DESCRIPTION QTY
APPLICABLE MODEL
EAY 1 61 54X
Harness
1992 MX-3 (1.6L, 4 Cyl.)
WARRANTY INFORMATION
(Applies to vehicles covered under warranty.)
Warranty Type Code:
A
Customer Comment Code:
A1
Damage Code:
AA*
Part No. of Main Cause:
EAY1 61 54X
Operation No.:
YY0089RX
Labor Hour:
0.3 Hrs.