MX-5 Miata L4-1.8L DOHC (1996)
-
If not as specified, inspect the harness and connectors.
-
If these harness and connector and OK, replace the EGR boost sensor.
EGR Boost Signal Side
-
Connect the SSTs (NGS) to the data link connector-2.
-
Turn the ignition switch to ON (engine OFF).
-
Select the PID/DATA MONITOR AND RECORD function on the NGS display.
-
Select the "EGRB V" and apply vacuum of 20 kPa (5.9 in Hg) to EGR boost signal voltage.
-
Measure and record the EGR boost signal voltage.
-
Further apply vacuum to 43 kPa (12.7 in Hg).
-
Measure the EGR boost signal voltage. Verify the difference between the voltages noted in steps 5 and 7 is as specified.
Specification: Approx. 1.5 V
-
If not as specified, inspect the harness and connectors.
-
If these harness and connector are OK, replace the EGR boost sensor.