MX-5 Miata L4-1.8L DOHC (1996)
EGR Valve Position Sensor: Testing and Inspection
INSPECTION
-
Disconnect the EGR valve position sensor connector.
-
Measure the resistance between terminals A and B by using an ohmmeter.
Specification: 2.7 kohms
-
If not as specified, replace the EGR valve.
-
Connect the EGR valve position sensor connector.
-
Connect the SSTs (Engine Signal Monitor) to the ECM.
-
Disconnect the vacuum hose from the vacuum tube and install a vacuum pump to the valve.
-
Turn the ignition switch to ON.
-
Measure the voltage at the ECM terminal 3J.
-
If not as specified, inspect the harness and connector between the EGR valve position sensor and the ECM terminal.
-
If these harness and connector are OK, replace the EGR valve.
USING THE NGS
-
Disconnect the EGR valve position sensor connector.
-
Measure the resistance between terminals A and B of the connector by using an ohmmeter.
Specification: 2.7 kohms
-
If not as specified, replace the EGR valve.
-
Connect the EGR valve position sensor connector.