MX-5 Miata L4-1.8L DOHC (1996)
Inspection Procedure
POWER ANTENNA RELAY INSPECTION PROCEDURE
1.
Check the antenna mast for damage.
^
If damaged, repair and retest.
^
If no damage is found, proceed to step 2.
2.
Inspect the power antenna relay connector (pin-4 arid 9) for corrosion and/or bent or pushed out terminals.
^
If the terminals are damaged, repair as necessary and retest.
^
If the terminals are not damaged, proceed to step 3.
3.
Disconnect the power antenna relay connector.
4.
Connect a jumper wire between the terminals of the female connector (pin-9).
5.
Observe the antenna operation.
Terminals to be
Power Antenna Operation
Short Circuited
B-G, F-H
Antenna should raise
B-H, C-F
Antenna should lower
^
If the power antenna operates smoothly, proceed to step 7.
^
If the antenna does not operate smoothly, proceed to step 6.
6.
Inspect the following and repair as necessary. If no problem(s) is found, replace the power antenna relay.