MX-5 Miata L4-1597cc 1.6L DOHC (1992)
Clutch Master Cylinder: Service and Repair
Clutch System Bleed
Fig. 2 Bleeding Clutch Hydraulic System
When bleeding the hydraulic assembly it is important that the fluid reservoir be kept at the 3/4 level or higher.
1.
Remove bleeder cap from clutch release cylinder and attach a vinyl hose to bleeder plug, Fig. 2.
2.
Insert opposite end of vinyl hose into a clear container.
3.
Slowly pump clutch pedal several times, then with pedal depressed loosen bleeder screw to let fluid and air escape.
4.
Close bleeder screw.
5.
Repeat steps 3 and 4 until no bubbles are seen in the fluid.
6.
Tighten bleeder screw to specification and install bleeder cap.
