MX-5 Miata L4-2.0L (2008)
Keyless Entry System
KEYLESS CONTROL MODULE REMOVAL/INSTALLATION [KEYLESS ENTRY SYSTEM]
1. Disconnect the negative battery cable.
2. Remove the side panel.
3. Remove the bolt and nut.
4. While inclining the keyless control module along the body panel in the direction indicated by the arrow, disengage the bracket tab from the hole in
the body panel.
5. Disconnect the keyless control module connector.
6. Remove the keyless control module.
7. Remove the screw, then remove the bracket.
NOTE: The screw which fixes the keyless control module and bracket is for a body ground connection. Be sure to secure the screw when
installing.
8. Install in the reverse order of removal.
Keyless Beeper
KEYLESS BEEPER REMOVAL/INSTALLATION [ADVANCED KEYLESS SYSTEM]
1. Disconnect the negative battery cable.
2. Remove the trunk side trim.
3. Remove the nuts.
4. Disconnect the connector.
