MX-5 Miata L4-2.0L (2008)
1. Place an alignment mark on the brake pipe and DSC HU/CM
2. Apply protective tape to the connector to prevent brake fluid from entering.
3. Remove the brake pipe.
Brake Pipe (DSC HU/CM-brake pipe joint) Installation Note
1. Align with the mark made before removing the brake pipe and temporarily install the brake pipe to the DSC HU/ CM.
Caution
^
If the brake pipe is tightened to the specified torque, it may be difficult to install it to the vehicle. Therefore, only temporarily tighten
the brake pipe so that it can still be moved.
Brake Pipe Installation Note
1. Align the marks made before removal and install the brake pipe to the DSC HU/CM and brake pipe joint referring to the figure.
2. Tighten the brake pipe to the specified torque using the commercially available flare nut wrench.
DSC HU/CM Connector Installation Note
1. After connecting the connector, verify that the lock lever is completely pushed in.
