MX-5 Miata L4-2.0L (2008)
1. Pull the lock lever up in the direction of the arrow.
2. Pull the connector toward the vehicle rear and remove it.
Brake Pipe Removal Note
1. Place an alignment mark on the brake pipe and ABS HU/CM
2. Apply protective tape to the connector to prevent brake fluid from entering.
3. Remove the brake pipe.
Brake Pipe (ABS HU/CM-brake pipe joint) Installation Note
1. Align with the mark made before removing the brake pipe and temporarily install the brake pipe to the ABS HU/ CM.
Caution
^
If the brake pipe is tightened to the specified torque, it may be difficult to install it to the vehicle. Therefore, only temporarily tighten
the brake pipe so that it can still be moved.
Brake Pipe Installation Note
1. Align the marks made before removal and install the brake pipe to the ABS HU/CM and brake pipe joint referring to the figure.
2. Tighten the brake pipe to the specified torque using the commercially available flare nut wrench.
ABS HU/CM Connector Installation Note
