MX-5 Miata L4-2.0L (2008)
7. Install the VSS.
Tightening torque
7.8 - 11 Nm (80 - 112 kgf-cm, 70 - 97 in-lbf)
8. Install the transmission.
9. Connect the VSS connector.
10. Connect the negative battery cable.
11. Install the battery cover.
[SJ6A-El] Automatic Transmission
VEHICLE SPEED SENSOR (VSS) REMOVAL/INSTALLATION [SJ6A-EL]
Caution:
^
Water or foreign material entering the connector can cause poor connections or corrosion. Be sure that water or foreign material do
not enter the connector when disconnecting it.
^
Do not damage the VSS.
1. Remove the battery cover.
2. Disconnect the negative battery cable.
3. Remove the tunnel member component.
4. Remove the middle pipe.
5. Remove the insulator.
6. Mark the manual shaft lever component as shown in the figure.
7. Separate the manual shaft lever component from the selector lever.
8. Disconnect the VSS connector.
