MX-5 Miata L4-2.0L (2008)
NOTE: The quick release connector can be removed by pushing the center of the retainer tabs.
3. Hold the center of the retainer tabs with the SST ends and press the retainer.
4. Pull the connector side and disconnect the quick release connector.
5. Raise a retainer tab using the SST and remove the retainer.
6. Cover the disconnected quick release connector and joint port with vinyl sheeting or a similar material to prevent it from becoming scratched or
dirty.
Type D Removal
CAUTION: When releasing the retainer locks, take extreme care not to damage the evaporative hose.
1. Release the locks between the retainer and joint port by pressing each retainer lock one by one using a flathead screwdriver or a similar tool.
2. Pull out the hose straight from the joint port and disconnect it.
NOTE: The retainer is attached to the pipe even after the connector is disconnected.
3. Cover the disconnected quick release connector and joint port with vinyl sheeting or a similar material to prevent it from becoming scratched or
dirty.
Type A Installation
NOTE: If the quick release connector O-ring is damaged or has slipped, replace the evaporative hose.
-
A checker tab is integrated with the quick release connector for new evaporative hoses. Remove the checker tab from the quick release
connector after the connector is completely engaged with the joint port.
1. Inspect the evaporative hose and joint port sealing surface for damage and deformation.
-
If there is any malfunction, replace it with a new one.
