MX-5 Miata L4-2.0L (2008)
9. Remove the VSS.
10. Install the VSS.
Tightening torque
3.9 - 6.9 N-m (40 - 70 kgf-cm, 35 - 60 in-lbf)
11. Connect the VSS connector.
12. Align the mark of the manual shaft lever component as shown in the figure.
13. Install the manual shaft lever component installation nut.
14. Install the insulator.
Tightening torque
8 - 11 Nm (82 - 112 kgf-cm, 72 - 97 in-lbf)
15. Install the middle pipe.
16. Install the tunnel member component.
17. Connect the negative battery cable.
18. Install the battery cover.
