MX-5 Miata L4-2.0L (2008)
Control Arm: Service and Repair
Front Lower Arm Removal/Installation
FRONT LOWER ARM REMOVAL/INSTALLATION
Caution:
^
Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the
wiring harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side)
and fix it to an appropriate place where the sensor will not be pulled while servicing the vehicle.
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
Caliper and Mounting Support Removal Note
1. Remove the caliper and mounting support from the steering knuckle and suspend it with a cable in a location out of the way.