MX-5 Miata L4-2.0L (2008)
2. Remove the wheel bearing from the rear knuckle using the SSTs.
3. After removing the bearing, repair any backing plate deformation.
Dust Cover Removal Note
Note: Remove the dust cover only if there is an abnormality.
1. Place an alignment mark on the dust cover and rear knuckle for proper installation.
2. Remove the dust cover using a chisel.
Bushing Removal Note
1. Remove the bushing from the rear knuckle using the SSTs.
Wheel Hub Bolt Removal Note
Note: Remove the wheel hub bolt only if there is an abnormality.
