mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

Seat Belt > < Air Bag Control Module|Removal and Installation|Page 3507
Page 1
background image

Air Bag(s) Arming and Disarming: Service and Repair

1. Turn the ignition switch to LOCK position.
2. Disconnect the negative battery cable and wait for more than 1 minute.
3. Perform needed service or repair procedures.
4. Reconnect negative battery cable.
5. Turn the ignition switch to ON position.
6. Verify that the air bag system warning light illuminates for approximately 6 seconds and then goes off.

-

If the air bag system warning light remains on, off, or repeats flashing after servicing, there are malfunctions in the system. Carry out the
inspection again.

Seat Belt > < Air Bag Control Module|Removal and Installation|Page 3507