MX-5 Miata LS L4-1.8L DOHC (2001)
Steering Gear: Service and Repair
Removal and Installation
STEERING GEAR AND LINKAGE REMOVAL/INSTALLATION
Caution:
-
Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if It is
pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place
where the sensor will not be pulled by mistake while servicing the vehicle.
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. After installation, inspect the toe-in.
Tie-rod End Ball Joint Removal Note
1. Separate the tie-rod end ball joint from the knuckle using the SST.