MX-5 Miata LS L4-1.8L DOHC (2001)
Shift Interlock Solenoid: Service and Repair
Shift-Lock Actuator Removal/Installation
SHIFT-LOCK ACTUATOR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the rear console.
3. Remove the indicator screws and light up the indicator panel.
4. Disconnect the shift-lock actuator connector.
5. Disconnect the P position switch connector.
6. Remove the shift-lock actuator.
7. Install a shift-lock actuator.
Tightening torque 0.7 - 1.2 Nm (8 - 12 kgf-cm, 6.2 - 10.6 inch lbs.)
8. Connect the P position switch connector.
9. Connect the shift-lock actuator connector.
10. Adjust the indicator panel. Install the screws in the order shown in the figure.
Tightening torque 1.5 - 2.4 Nm (16 - 24 kgf-cm, 14 - 21 inch lbs.)
11. Install the rear console.
12. Verify correct operation of the shift-lock system.
13. Connect the negative battery cable.
