MX-5 Miata Mazdaspeed L4-1.8L DOHC Turbo (2004)
6. Install the locknut using the SST (49 B032 320).
Tightening torque 40 - 49 Nm (4.0 - 5.0 kgf-m, 29 - 36 ft. lbs.)
Hermetic sealing inspection
1. Connect the SSTs to the power cylinder section of the gear housing.
2. Apply 53.3 kPa (400 mm Hg, 15.7 in Hg) vacuum with a vacuum pump and verify that it is held for at least 30 seconds.
^
If the vacuum is not held, replace the oil seal.
STEERING GEAR AND LINKAGE INSPECTION (ENGINE SPEED SENSING POWER STEERING)
Tie-rod End Inspection
1. (Refer to "Tie-rod End Inspection", under Steering Gear; Service and Repair; Disassembly and Assembly; Manual Steering.)
Tie Rod Inspection
1. (Refer to "Tie Rod Inspection", under Steering Gear; Service and Repair; Disassembly and Assembly; Manual Steering.)
Steering Rack Inspection
1. (Refer to "Steering Rack Inspection", under Steering Gear; Service and Repair; Disassembly and Assembly; Manual Steering.)
