MX-5 Miata Mazdaspeed L4-1.8L DOHC Turbo (2004)
Lower Arm Bushing (Crossmember Side) Removal Note
1. Press the lower arm bushing out using the SSTs and a socket as shown.
Lower Arm Bushing (Knuckle Side) Removal Note
1. Press the lower arm bushing out using the SST and a socket as shown.
Lower Arm Bushing (Knuckle Side) Installation Note
1. Apply soapy water to the lower arm bushing.
2. Press the bushing in using the SST and a socket in the direction of the arrow.
Caution:
^
Install the bushing with the mark to the front.
Lower Arm Bushing (Crossmember Side) Installation Note
1. Apply soapy water to the lower arm bushing.
2. Press the bushing in using the SST and a socket in the direction of the arrow.
Upper
REAR UPPER ARM REMOVAL/INSTALLATION
Caution:
^
Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is
pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place
where the sensor will not be pulled by mistake while servicing the vehicle.
