MX-5 Miata Mazdaspeed L4-1.8L DOHC Turbo (2004)
Back Window Glass: Service and Repair
REAR WINDOW GLASS REMOVAL
Detachable Hardtop
NOTE: The rear window molding is a replacement part.
1. Remove the rear window molding.
2. Apply protective tape along the edge of the body to protect it from damage.
3. Remove the rear window glass installation nuts.
4. Make a hole through the sealant and the dam from the inside of the vehicle using an awl.
WARNING: Using a SST (piano wire) with bare hands can cause injury. Always wear gloves when using a SST (piano wire).
5. Pass the SST (piano wire) through the hole.
6. Wind each end of the SST (piano wire) around a bar.
NOTE: Use the entire length of SST (piano wire) to prevent it from breaking when cutting through the sealant.
7. Working with another person, saw through the sealant around the edge of the glass, being careful not to damage the body.
WARNING: Using a razor with bare hands can cause injury. Always wear gloves when using a razor.
8. Use a razor to cut the places of rear window glass installation nuts where the SST (piano wire) will not cut.