MX-5 Miata Mazdaspeed L4-1.8L DOHC Turbo (2004)
4. Insert the blade of the SST (Sealant Remover) into the sealant, and pull on the bar to cut the sealant near the glass as shown.
5. Remove as much sealant as possible from between the body and the glass.
6. Carefully clean around the edge of the glass and the adhesion surface of the body.
CAUTION: Keep the area free of dirt and grease and do not touch the surface or the primer may not properly bond to the surface of the glass and
body which may cause leaks to occur.
7. Apply primer onto the bonding area of the new rear window molding using a brush. Allow the primer to dry for approximately 30 minutes.
8. Apply a 3.0 mm {0.12 in} bead of sealant between the glass and the body.
9. Reshape the sealant as shown if necessary.
