MX-5 Miata Mazdaspeed L4-1.8L DOHC Turbo (2004)
1. Cut away the old sealant using a razor so that 1 - 2 mm {0.04 - 0.07 in} thickness of sealant remains around the circumference of the frame.
-
If all the sealant has come off in any one place, apply some primer after degreasing, and allow it 30 minutes to dry. Then put on new sealant to
create 2 mm {0.08 in} layer.
2. Clean and decrease an approximately 50.0 mm {1.97 in} wide strip around the circumference of the glass and the bonding area on the body.
3. Securely bond a dam along the circumference of the glass 1.0 mm {0.28 in} from the edge.
4. Install spacers into the hole.
5. Temporarily install the glass onto the body and adjust the glass-to-body clearance.
6. Make a mark on the glass directly above the V-notch of spacers.
7. Remove the windshield.
CAUTION: Keep the area free of dirt and grease, and do not touch the surface or the primer may not properly bond to the surface of the glass
and body which may cause leaks to occur.
8. Use a brush to apply primer to the bonding area of the glass, the body and the molding within the region shown.
NOTE: Use only glass primer on the glass, and body primer on the body and the molding. Allow it to dry for approximately 30 minutes.
9. Align the edge of the protector to the spot mark.
