MX-6 L4-1991cc 2.0L DOHC (1993)
Air Dam: Customer Interest
Air Dam Skirt, Front - Loose
Bulletin No.: 020/94
Issued: 4/28/94
Revised: 7/10/94
Category
S
Applicable Models
1993-94 626/MX-6
Subject:
LOOSE FRONT AIR DAM SKIRT
The revised section of this bulletin is indicated by an asterisk (*). Replace the original bulletin with this revised copy.
APPLICABLE MODELS/VINS
All 1993 626/MX-6
1994 626/MX-6 - Vehicles with a VIN of 1YVGE .... R5170626 or lower
NOTE:
The asterisk (*) in the VIN can be any number (0 through 9) or "X".
DESCRIPTION*
The front air dam skirt may be loose at the front cross member. This is caused by loose or missing attaching grommets.The air dam skirt may remain
attached by a single bolt. To prevent this problem, an additional bolt and weld nut are added during production.
REPAIR PROCEDURE
* Replace the factory installed grommets with aftermarket license plate nuts, screws and washers.
1.
Insert nylon nuts into crossmember.
2.
Place screw with washer through air dam skirt and secure into nylon nut. Refer to illustration.
PARTS INFORMATION
Mazda recommends the use of Auveco fasteners. These fasteners are available through Sarjo at 1-800-447-2766. Listed below are applicable part
numbers.
Sarjo Part Number
Description
8606
Flat Washer
9603
Screw
11719
Nylon Nut