MX-6 L4-1991cc 2.0L DOHC (1993)
^
If broken, strip approximately 25 mm (1 in.) of protective covering from the wire on each side of The clip and repair the wire as shown in Fig.
2.
^
If not broken in that area, inspect the entire wire to identify the damaged area or refer to the work shop manual for instructions.
NOTE:
After repair, do not route wires through the base clip.
5.
Tape the switch harness to the illumination light harness as shown in Fig. 3
6.
Verify repair.
7.
Install front console.
WARRANTY INFORMATION
(Applies To Verified Customer Complaints On Vehicles Covered Under Normal Warranty. Refer To The SRT Microfiche For Warranty Term
Information.)
Warranty Type:
A
Symptom Code:
61
Damage Code:
9Q
Part Number Main Cause:
BR72 46 040B
or GC2B 46 040
Quantity:
0
Operation Number:
YY0218RX
Labor Hours
0.5Hrs. (includes
cost of aftermarket
materials)