MX-6 L4-1991cc 2.0L DOHC (1993)
6. Separate the TSS sensor from the pump.
7. Remove the nine (9) pump mounting bolts.
8. Install the Special Service Tools (SSTs) on the pump.
9. Install a large screwdriver through the TSS sensor hole. Do not locate the screwdriver on the reverse clutch hub tabs.
10. Remove the pump while holding the components into the case with the screwdriver. Remove the #1 thrust bearing. This bearing may be attached to
the pump support or on the reverse clutch hub.
11. Remove the pump support mounting bolts.
