MX-6 L4-1991cc 2.0L DOHC (1993)
5. Install the pump support on the oil pump body.
6. Install and tighten the four pump support-to-oil pump body bolts to 13 Nm (10 ft. lbs.) and remove the SST (alignment pins). Install and tighten
the two remaining mounting bolts to 13 Nm (10 ft. lbs.).
7. Install a new seal ring on the oil pump body. Ensure that the white stripe is visible all around the pump.
NOTE: Ensure that the scarf cut seals are overlapped correctly.
8. Install seven new seal rings on the pump support.
