MX-6 L4-1991cc 2.0L DOHC (1993)
Wiper Arm: All Technical Service Bulletins
Wiper Arm - Rattling Noise From Right Hand Side
Bulletin No.: 006/96
Issued: 01/23/96
Revised
Category
S
APPLICABLE MODEL/S
1993-95
626 / MX-6
Subject:
CREAK / RATTLE NOISE FROM PASSENGER SIDE WIPER
APPLICABLE MODELS/VINS
All 1993-95 626 / MX-6 vehicles.
DESCRIPTION
A rattle noise from the cowl area or a creak noise from the passenger side front windshield may be heard during windshield wiper operation. This noise
may be caused by broken spot welds on the windshield wiper arm support bracket.
Customers complaining of this noise should have the vehicle inspected and if necessary, repaired according to the instructions in this bulletin.
NOTE:
Place a copy of this bulletin in the NVH manual for future reference.
REPAIR PROCEDURE
1.
Verify noise.
^
If the noise is coming from the cowl area during windshield wiper operation, proceed to step 2.
^
If the noise is not related to windshield wiper operation, refer to the workshop or NVH manual for troubleshooting instructions.
2.
Remove the wiper arms and cowl grill. Refer to section S of the workshop manual.
