MX-6 L4-1991cc 2.0L DOHC (1993)
3.
Inspect the two spot welds. Refer to Fig. 1.
^
If broken, proceed to step 4.
^
If not broken, inspect the area for other causes or refer to the workshop manual or NVH manual for troubleshooting instructions.
4.
Drill 1/4 inch (6 mm) hole through the top of the two (2) spot welds. Refer to Fig. 2
5.
Remove metal shavings.
6.
Clean bracket with denatured alcohol and apply silicone sealer at both holes (to prevent rusting).
