MX-6 L4-2184cc 2.2L SOHC Turbo F2 (1989)
Technical Service Bulletin # S01291
Date: 910409
Body - Water Leak In Front Floor, Headliner, Trunk Area
Bulletin No.
012/91
Issued
4/9/91
Revised
Category
S
Applicable Model/s
1988-'91 626/MX-6 (USA made)
Subject
WATER ENTERING INTERIOR
DESCRIPTION
Some 1988-'91, USA made, 626/MX-6 models may have water entering the vehicle in front floor, headliner (sunroof) or trunk areas. If a customer
complains about this, perform the appropriate repairs. These areas may also be discovered during PDI or while in dealer inventory.
If the area where water entered the vehicle cannot be confirmed, perform a water leak test. See Locating Source of Water Leaks section under
appropriate area of water entry.
NOTE:
Some of these procedures should only be performed by personnel experienced in body shop work.
WATER ENTRY
LOCATION OF LEAKS
NOTE:
An alternate method for locating some water leaks (i.e. around windshield and door seals) is to turn the blower on High, select Fresh Air Intake and close
all doors. Apply soap suds to suspected areas. Large bubbles will appear at leak areas.
I. Right Front Side of Passenger Compartment Area
Locating Source of Water Leak
1.
Remove dash undercover, scuff plate and kick panel. Pull back carpet and pad. Remove carpet and pad, if necessary.
2.
At least 12 minutes should be spent during the initial hose testing, as the water may have to move through several body seams before being
detected.
3.
Turn water pressure on hose so that a 12"-18" stream of water is present while hose is vertical.
4.
DO NOT direct water into blower motor opening (under cowl panel).
5.
Get inside vehicle. Use a flash light to help locate water entry point.