MX-6 L4-2184cc 2.2L SOHC Turbo F2 (1989)
4.
If necessary, position hose so there are no loops, kinks or pinched areas. Check for kinks at drain hose clip. Repeat water test. Make sure sunroof
drains properly with no leaks. Figure 28.
5.
If necessary, install a new hose.
6.
If hose routing is okay and hose is intact, check for leaks at rear windshield.
Area C: Inspect rear headliner or sunroof sliding panel.
1.
Remove rear header trim. Remove rear-shoulder seatbelt mounts and inside "C" pillar trim panel(s). Figure 27.
HINT:
Leave lower attaching screws in place and tilt "C" pillar trim back.
CAUTION:
Do not use too much force when pulling on "C" pillar trim. Permanent damage (white stress marks) may result.
2.
Remove headliner retaining clips (one [1] plastic and three [3] metal per side).
CAUTION:
Do not remove the two (2) center plastic retaining clips.
3.
Make sure drain hose routing is correct. Check for damage along drain hoses by pulling down headliner.
