MX-6 L4-2184cc 2.2L SOHC Turbo F2 (1989)
Vacuum Pump Connection -- Evaporative Pipe
14.
Disconnect the evaporation hose from the evaporation pipe.
15.
Connect the vacuum pump to the evaporation pipe.
16.
Operate the vacuum pump and verify that no vacuum is held.
17.
If vacuum is held, check the evaporation pipe for clogging.
NO. 1 PURGE CONTROL VALVE
Checking Purge Control Valve Port "A"
1.
Blow through the purge control valve from port "A" and check that air does not flow.
2.
Connect a vacuum pump to the purge control valve.
3.
Apply 110 mmHg (4.33 in.Hg) vacuum, and blow through port "A" again; air should flow.
NO. 2 PURGE CONTROL VALVE
Checking Purge Control Valve Port "B"
1.
Disconnect vacuum hose "B" from the evaporation pipe.
2.
Blow through the hose and verify that air flows freely.
VACUUM SWITCH VALVE
1.
Remove vacuum switch valve.
