MX-6 L4-2184cc 2.2L SOHC Turbo F2 (1989)
Bypass Air Control Valve
2.
Blow air through the valve from port "A" and check that air comes out of port "B" when the BAC valve is cold.
3.
If not correct replace the BAC valve.
Bypass Air Control Valve Installation
4.
To install the BAC valve, thoroughly clean the mating surfaces of the valve and throttle body. Apply sealant to both sides of the gasket and
tighten the screws.
ISC VALVE
1.
Disconnect the ISC valve connector.
ISC Valve Resistance Test
2.
Connect an ohmmeter to the terminals of the ISC valve.
3.
Check the resistance. The resistance at normal operating temperature should be 6.3-9.9 Ohms.
4.
If not correct, replace the BAC valve.
IDLE SWITCH
1.
Disconnect the idle switch connector.
