MX-6 V6-2496cc 2.5L DOHC (1996)
2.
Confirm that the "0-Ring" is in place behind the antenna bezel (mounting nut).
3.
Install the antenna bezel (mounting nut) using snap-ring pliers.
CAUTION:
Take care not to scratch or damage the mounting nut.
Pin Striping
Door Panels
1.
If necessary, remove the pin stripe starting at one end or edge.
CAUTION:
Avoid damage to the exterior paint surface by not using pointed or sharp tools to remove the existing stripes.
2.
Remove adhesive residue using kerosene, isopropyl alcohol or Pre-Kleano wax and a soft clean cloth.
NOTE:
Residue may be difficult to see and may still be present after removal attempts. To confirm that the residue is completely removed, use your hand to
gently feel around the area where the residue was present.
3.
Rinse the area with clean water and dry with a clean cloth.
4.
Use a spray bottle to liberally spray the area with water.
5.
Remove the adhesive release liner paper from the back of the pin stripe.
CAUTION:
USE HANDLING TABS when peeling the liner paper to expose the pin stripe's adhesive. Handling tabs will reduce the possibility of fingers
contacting the pin stripe's adhesive surface.
6.
Position the door pin strip's pre-mask tape extension top edge along the feature line at the top of the door.
7.
While maintaining horizontal alignment, position the left and right edges of the pre-mask tape by locating the vertical side of the notches to the
door panel edges. Refer to Fig. 6
